Experimental investigation in the performance and emissions of the CI engine fueled with Waste vegetable oil and its titanium and aluminum nanoparticle blends
Author: M.NAVEEN KUMAR, Dr. SANJEEV TRIPATHI
Category: Engineering, Science and Mathematics
Abstract:
In this paper, research is carried out to find the differences in the parameters of performance and emission in CI engine when esterified Waste Vegetable oil blended with different Nano-additives are used as fuel. Experiment is carried out to compare the effects in the performance and emission between Waste Vegetable oil blended with tio2, al203 Nano-additives at different injection pressures.It is observed that all the biodiesel blends on an average had lower emissions when compared to diesel and Al2O3 blends had least NOX emissions along with WVO B30 Al2O3 at 240bar having the least CO%. No noticeable changes were observed in the performance of the engine with these blends as compared to diesel.
References:
G.R. Kannan, R. Karvembu, R. Anand, “Effect of metal based additive on performance emission and combustion characteristics of diesel engine fuelled with biodiesel”, Applied Energy, 88, pp. 3694–3703, 2011.
S. Karthikeyan, A. Elengo, A. Prathima, “Performance and emission study on zinc oxide nanoaprticles addition with pamoline stearin wax biodiesel”, Journal of Scientific and Industrial research, 73, pp. 187-190, 2014.
Ali M.A. Attia, Ahmed I. El-Seesy, Hesham M. ElBatsh, Mohamed S. Shehata, “Effects of alumina nanoparticles additives into jojoba methyl ester-diesel mixture on diesel engine performance”, ASME International Mechanical Engineering Congress and Exposition, DOI: 10.1115/imece2014-39988, Nov 2014.
K. Fangsuwannarak and K. Triratanasirichai “Improvements of Palm Biodiesel Properties by Using Nano-TiO2 Additive, Exhaust emission and Engine Performance” The Romanian Review Precision Mechanics, Optics & Mechatronics, 2013, No. 43.
J. Sadhik Basha, R. B. Anand, “The Influence of Nano Additive Blended Biodiesel Fuels on The Working Characteristics of a Diesel Engine”, J Braz. Soc. Mech. Sci. Eng., 35, pp. 257–264, 2013.
D. Ganesh and G. Gowrishankar “Performance and Emission Characteristics of Jatropha Biodiesel (B100) in a Single Cylinder, Air Cooled, Direct Injection Diesel Engine”. Research Gate article September 2011 DOI: 10.1109/ICECENG.2011.6058240.
V. Arul Mozhi Selvan, R. B. Anand and M. Udayakumar “Effects of Cerium Oxide Nanoparticle Addition in Diesel AND Diesel-Biodiesel-Ethanol Blends on the Performance and Emission Characteristics of a CI Engine”. ARPN Journal of Engineering and Applied Sciences. VOL. 4, NO. 7, SEPTEMBER 2009 ISSN 1819-6608.
Sajith V., Sobhan C.B., Peterson G.P. Experimental investigations on the effects of cerium oxide nanoparticle fuel additives on biodiesel. Advances in Mechanical Engineering 2010: ID 581407
Guru M., Karakaya U., Altiparmak D., Alicilar A. Improvement of diesel fuel properties by using additives. Energy Conversion & Management 2002; 43:1021–1025.
G.R. Kannan, R. Karvembu, R. Anand, “Effect of metal based additive on performance emission and combustion characteristics of diesel engine fuelled with biodiesel”, Applied Energy, 88, pp. 3694–3703, 2011.